• Equipment Services & Repair (construction, farm, substation, logging & mining)

• Welding & Fabrication

• Arc Gouging

• Line Boring & Bore Welding

• Marine Repair & services

Our standard service rate is $120.00 per hour. We do not charge a service call fee. Service rates simply start when we pull out of the driveway.

If you are located outside our area, contact us to receive an estimate. let us know what the scope of work & where you are located. We can generally get a pretty close estimate for cost of the repair.

The flat rate services listed in the dropdown menus below can be modified depending on your specific needs. Give us a call to discuss your options.

Includes- Drain & service gear oil, replace drain plug gaskets, remove & grease prop, test run & confirm functions.

2-30hp $145.00

40hp-up $175.00

Drain & service engine oil & gear oil. Replace engine oil filter. Remove prop & grease prop shaft splines. Run engine in test tank & confirm all functions.

2.5-6hp $160

8-25hp $175

30-40hp $195

50-70hp $210

75-115hp $245

150-200hp $295

225hp-up $360

Inboard Jet- Drain & service engine oil. Replace oil filter. Inspect jet impeller. Grease pump bearing. Inspect coupler/u-joint assembly. Grease shift gate & cables.

Direct Drive- Drain & service engine oil & transmission fluid. Replace engine oil filter. Inspect/adjust driveshaft packing. Lube cables where applicable.

Stern Drive- Drain & service engine oil & gear oil. Replace engine oil filter. Remove prop & grease prop shaft splines. Grease zirk fittings & cables.

Jet Drive $255

Direct Drive $310

Stern Drive $310

We recommend doing this service every 100hrs, or every other year. 100hr service on Mercury Sport Jet include the following:

Replace spark plugs & fuel filters. Drain & service gearbox. Remove reverse bucket/nozzle assembly & stator housing. Replace seal, & protector in stator & service. Inspect impeller. Grease cables.

175hp-$495

200-250hp- $595 (spark plugs are much more expensive in these engines)

Whether you are purchasing a used vessel, or selling your own, we can provide a detailed report on the condition of your boat &/or engine.

The standard labor rate applies to these inspections. Depending on scope of work will determine price. (i.e. a small outboard will be less than a large inboard)

Winterizing packages are by far the cheapest & best way to take care of annual service items on your boat. (Pricing includes parts & labor)

Stern Drive-

Basic $210.00

Full $365.00

V-Drive/Direct Drive-

Basic $210.00

Full $365.00

Jet Boats-

Basic $155.00

Full $295.00

The following is an example of a full winterize service on a stern drive inboard:

Engine oil (up to 6 quarts) & gear oil service. Replacement of oil & fuel filters. Removal of outdrive & inspection of- engine alignment, engine coupler, gimbal bearing & u-joints (includes new outdrive gasket set) Gimbal bearing & all pivot points are greased. Remove prop & inspect/grease splines. Perform systems check on boat. Fuel stabilizer is added to fuel tank. Run & fog engine with rust inhibitor. All raw water is drained from engine cooling system, wash down pumps & any other accessories.

Shrink wrapping is priced at $20per linear foot. This covers the labor & materials for a basic shrink wrap. Zippered entrances, or any additional structural requirements will add to the cost. (We do not charge extra for boats with wake board towers)